Article
  • Effect of Resin Viscosity and Lubricants on Surface and Mechanical Properties of Glass Fiber Reinforced Polymer in Rapid Heat Cycle Molding
  • Aimin Zhang , Yang Hui, and Junji Hou

  • Key Laboratory for Liquid-Solid Structural Evolution and Processing of Materials (Ministry of Education), School of Materials Science and Engineering, Shandong University, Jinan, Shandong 250061, PR China

  • 금속 열순환 성형에서 수지의 점도와 윤활유가 유리 섬유 강화 고분자의 기계적 물성과 표면에 미치는 영향
Abstract

Conventional injection molding (CIM) and rapid heat cycle molding (RHCM) methods are used to prepare ABS and (acrylonitrile-butadiene-styrene)/glass fiber copolymer (ABS/GF) plastic parts. Pentaerythritol stearate (PETS) and silicon particles are chosen as lubricants. Effect of resin viscosity and lubricants on properties of plastic parts was investigated. The results show that resin viscosity has some effect on surface quality of plastic parts in CIM process but no effect in RHCM process. ABS/GF plastic parts molded in RHCM process exhibit higher tensile, higher flexural strength and lower impact strength. Silicon is more effective in RHCM process than in CIM process.


Keywords: injection molding, rapid heat cycle molding, properties, viscosity, lubricants

  • Polymer(Korea) 폴리머
  • Frequency : Bimonthly(odd)
    ISSN 0379-153X(Print)
    ISSN 2234-8077(Online)
    Abbr. Polym. Korea
  • 2022 Impact Factor : 0.4
  • Indexed in SCIE

This Article

  • 2018; 42(6): 974-981

    Published online Nov 25, 2018

  • 10.7317/pk.2018.42.6.974
  • Received on May 2, 2018
  • Revised on Jun 7, 2018
  • Accepted on Jun 11, 2018

Correspondence to

  • Aimin Zhang
  • Key Laboratory for Liquid-Solid Structural Evolution and Processing of Materials (Ministry of Education), School of Materials Science and Engineering, Shandong University, Jinan, Shandong 250061, PR China

  • E-mail: zhangam@sdu.edu.cn